Metallkraft HPS 115 DS, Руководство по эксплуатации

Страница: 19 / 42

- 17
In order to install or change the punch tools you will need the following tools:

Hook key
 Soc. head cap bolt key ( 6 mm )
 Screw key ( 24 mm )
WHILE ORDERING SPARE STAMPS AND MATRIXES, PLEASE ALWAYS INFORM OF THE
FOLLOWING: MODEL, TYPE AND MANUFACTURING NUMBER OF THE MACHINE.
Below we explain step by step now the hole stamp and cutting case are changed:
1) In order to take out the cutting case, move the machine to a position where there is enough
2) Disconnect the machine at machine switch
3) Open the scraper, loose the coupling nut, fixing screws of the cutting case delivery plate and the
M12 screws, which hold the cutting case. Remove the coupling nut together with the hole
stamp and adapter. Remove the cutting case.
4) Place the required punch tool set. Make sure that the hole stamp and cutting case are correctly
fixed.
5) Connect the machine and than position at “adjustment”.
6) Move the hole stamp slowly towards the cutting case. Push the cutting case delivery plate
correctly so that the hole stamp and cutting case are completely arranged.
7) Adjust the cutting case delivery plate in a manner that the cutting distance which remains
between the hole stamp and cutting case is fully equal and draw the delivery plate fixed in this
station.
8) Check whether or not the receiving plate has been deviated during the drawing. If the cutting is
not equal, you should repeat the point 8. as soon as the plate is fixed the cutting distance is
equal, adjust the machine to “normal”.
9) Take the scraper back then adjust the distance between the scraper and cutting case according
to the thickness of the material to the machined.
10)Adjust the course adjustment in such a manner that the shortest possible way should be left
back.
11) In order to protect the operations, fix the macralon protection before you start working.