c180pKhd Assembly InstructIons
a. Locate the three separate plates. Lay the plates on a flat surface as shown in Figure 1 below.
b. Place the rounded inner edge of one plate against the vertical jet pipe in center of cooker.
The plate will fit around the appliance leg using the cutouts provided on the plate. Repeat
procedure with the second plate. Align the bolt holes of the first and second plate and attach
with bolt, lock washer and nut. Repeat procedure with third plate. Tighten all bolts/nuts.
Reference below Figure 2 for picture of a proper heat plate assembly.
14
c180pKhd hose Assembly InstructIons
1. Wrench tighten the 3/8” female flare swivel to the brass adapter.
2. The hose to burner (brass adapter) connection must be tightened and leak tested.
3. Go to the
use and care section
of this manual for further instructions.
leg
cutouts
bolt
holes
Vertical heat plate
cutout
Vertical heat plate
Figure 1
Figure 2
* Models may vary from picture.
jet pIpe (2)
3/8 FemAle
FlAre swIVel
orIFIce cAp (2)
(do not remoVe thIs FIttIng)
the orifice is the drilled hole in the brass cap
which should be pointing up directly into the jet pipe.
AdjustAble regulAtor
type 1
connectIon
brAss
AdApter
20 lb.
lp gAs
cylInder
