Metal-Fach N280, Инструкция по эксплуатации/Каталог запасных частей

Страница: 25 / 32

25
6.4. Lubrication
Lubrication of the spreader systems in accordance with the lubrication schedule ensures better performance
and protects from premature wear.
Follow these rules when lubricating:
- before attempting to lubricate, thoroughly clean all grease nipples and areas around the lubrication points
from mud and dust;
- feed the grease into the nipple until the fresh grease flows out of the spaces between mating parts;
- apply fresh grease on the land wheel bearings by first removing the wheels with the hubs – then wash the hubs
and pivots with Diesel fuel and fill the hub lubricating chambers with fresh grease;
- replace the transmission gearbox oil directly after stopping the spreader (the oil temperature will be higher,
which facilitates draining it from the gearbox);
- flush the gearbox with Diesel fuel before priming with fresh oil;
- lubricate the telescopic jointed shafts in accordance with the shaft operating manual.
Perform the lubrication of the wheel bearing during the inspection and adjustment of the brakes. When
replacing the wheel hub bearings, remove all grease from the hub chambers. After each year of operation, remove
the hubs with their bearings, wash the bearings and the hub chamber and then refill with fresh grease. The
lubrication points are showed in the lubrication diagrams.
All lubrication points indicated with stickers must be greased or checked for grease level before starting
the spreader. Use ŁT-42, ŁT-43 or any other high-performance bearing grease. The transmission gearboxes are
primed with HIPOL 15 oil.
The socket wheel grease nipples of the floor conveyor do not require lubrication, since self-lubricating
bushings are installed in these assemblies. Force feed grease to clean the mating surfaces during inspection or
after removing the adapter.
Lubrication schedule
Lubrication
point no.
Name of the spreader component to be
lubricated
Lubricant type Lubrication method
1 Conveyor stretcher wheels ŁT-42 or ŁT- 43
lubrication points
(not required)
2 Spreader rear shaft bearing ŁT-42 or ŁT- 43 lubrication points
3 Expander bearing ŁT-42 or ŁT- 43 lubrication points
4 Road wheel bearing ŁT-42 or ŁT- 43
periodic
replacement
5 Conveyor chains Hipol 15 apply to the surface
6 Support ŁT-42 or ŁT- 43
periodic
replacement
7 Intermediate drive bearing ŁT-42 or ŁT- 43 lubrication points
8 Transmission gearbox Hipol 15
periodic
replacement
9 Suspension spring pin ŁT-42 or ŁT- 43 lubrication points