ENGLISH
7
ENG
Mount the machine on the screw only when it is
switched off.
Wear ear protectors.
Exposure to noise can
cause hearing loss.
Materials that generate dusts or vapours that may
be harmful to health (e.g. asbestos) must not be
processed.
LED (3): Do not view LEDs directly through optical
instruments, LED class 1M, classified as per
IEC 60825-1: 2003, wavelength: 400-780 nm;
t
imp
=300 µs, 5 lm.
SYMBOLS
V ............ volts
....... direct current
n
0 ...............
rated speed
../min ...... revolutions per minute
rpm ........ revolutions per minute
See page 2.
1 Hexagon socket attachment for hexagon
screwdriving bits
2 Locking sleeve
3 LED light
For working on dimly lit areas. The LED lights
light up when the machine is switched on.
4 Rotational direction switch / Transporting
safety device
5 Trigger
6 Button for battery pack release
7 Battery pack
Remove the battery pack from the machine
before any adjustment or maintenance is
carried out. Before fitting the battery pack, make
sure that the machine is switched off.
5.1
The machine's multifunctional monitor-
ing system
If the machine switches off automatically, the
machine electronics have activated auto-
matic protection mode. A warning signal sounds
(continuous beeping). The beeping stops after a
maximum of 30 seconds or when the trigger is
released (5).
In spite of this protective function, over-
loading is still possible with certain appli-
cations and can result in damage to the
machine.
Causes and remedies:
1.
Battery pack almost flat
(the electronics
prevent the battery pack from discharging
totally and avoid irreparable damage).
If the battery pack is almost flat, it must be
recharged.
2. Long continuous overloading of the machine
will activate the
temperature cut-out
.
Leave the machine or battery pack to cool.
Note: The machine will cool more quickly if you
operate it at idling speed.
5.2
Battery pack
Charge the battery pack before use.
If performance diminishes, recharge the battery
pack.
Removing the battery pack
Press the battery pack release button (6) and
remove the battery pack (7).
To fit
Slide in the battery pack (7) until it engages.
5.3
Setting the direction of rotation,
engaging the transporting safety
device (switch-on lock)
Do not actuate the rotation selector
switch or engage the transportation lock
(4) unless the motor has stopped
completely!
Actuate the rotational direction switch /
Engage the transportation lock (4)
R
= Right rotation set
(insert screws)
L
= Left rotation set
(remove screws)
0
= Central position: transportation lock
setting
(switch-on lock)
5.4
Switching on and off
To switch on:
press the trigger switch (5).
Switching off
: Release the trigger (5).
5.5
Speed / Tightening torque
The speed and tightening torque are connected
directly. The lower the speed, the lower the tight-
ening torque.
4
Overview
5
Initial Operation/Setting
