Metabo HPT P 18DSL, Инструкции по безопасности и руководство пользователя

Страница: 15 / 68

Carbide blade
(Double edged
blade type)
Set plate (B)
Fig. 16
(2) As shown in Fig. 17, mount the new carbide blade
by sliding it on the set plate (B) so that the blade tip
projects by 1 mm from the end of the cutter block.
Fig. 17
(3) As shown in Fig. 18, fi x the bolts at the blade holder
after blade replacement has been completed.
Fig. 18
(4) Turn the cutter block over, and set the other side in the
same manner.
3. Adjustment of carbide blade height
CAUTION
If the carbide blade’s heights are inaccurate after
above procedures have been completed, carry
out the procedures described below.
(1) As shown in Fig. 19, use the box wrench to loosen
the three bolts used to retain the carbide blade, and
remove the blade holder.
Blade holder Box wrench
Bolt
Fig. 19
(2) As shown in Fig. 20, after removing the carbide blade,
slide set plate (B) in the direction indicated by the
arrow to disassemble set plate (B).
Set plate (B)
Fig. 20
(3) Loosen the 2 screws holding on the carbide blade and
set plate (A), set plate (B).
(4) As shown in Fig. 21, 22, press the turned surface of
set plate (A) to the wall surface b while adjusting the
carbide blade edge to the wall surface a of the set
gauge. Then, tighten them with the 2 screws.
Machine screw
Fig. 21
Turned surface
Set plate (A)
Set plate (B)
Carbide blade
(Double edged blade
type)
Set gauge
Wall surface a
Wall surface b
Fig. 22
15
English
000Book̲P18DSL.indb 15 000Book̲P18DSL.indb 15 2018/10/16 17:38:41 2018/10/16 17:38:41