24.
ALWAYS
wear a mask or respirator to protect yourself
from dust or potentially harmful particles generated
during the grinding operation.
25.
ALWAYS
fi
rmly grip the body handle and side handle
while operating the grinder.
26.
ALWAYS
have a trial run before grinding commence.
(see Test the grinder before using on page 10).
27.
ALWAYS
follow the instructions contained in this
manual when replacing the depressed center wheel.
28.
ALWAYS
be careful with buried object such as an
underground wiring.
Touching these active wiring or electric cable with this
tool, you may receive an electric shock.
Con
fi
rm if there are any buried object such as electric
cable within the wall,
fl
oor or ceiling where you are
going to operate here after.
29.
Be careful of brake kickback.
This disc grinder features an electric brake that
functions when the switch is released. As there is
some kickback when the brake functions, be sure to
hold the main body securely.
30.
De
fi
nitions for symbols used on this tool
V
............ volts
.......... alternating current
Hz
.......... hertz
A
............ amperes
n
o .......... no load speed
n
............ rated
speed
W
........... watt
.......... Class II Construction
---/min .... revolutions per minute
ø ............ wheel diameter
DOUBLE INSULATION FOR SAFER
OPERATION
To ensure safer operation of this power tool, metabo HPT
has adopted a double insulation design. “Double insulation”
means that two physically separated insulation systems
have been used to insulate the electrically conductive
materials connected to the power supply from the outer
frame handled by the operator. Therefore, either the symbol
“ ” or the words “Double insulation” appear on the power
tool or on the nameplate.
Although this system has no external grounding, you
must still follow the normal electrical safety precautions
given in this Instruction Manual, including not using the
power tool in wet environments.
To keep the double insulation system e
ff
ective, follow
these precautions:
○
Only metabo HPT AUTHORIZED SERVICE CENTER
should disassemble or assemble this power tool, and
only genuine metabo HPT replacement parts should
be installed.
○
Clean the exterior of the power tool only with a soft
cloth moistened with soapy water, and dry thoroughly.
Never use solvents, gasoline or thinners on plastic
components; otherwise the plastic may dissolve.
SAVE THESE INSTRUCTIONS
AND
MAKE THEM AVAILABLE TO OTHER USERS
AND
OWNERS OF THIS TOOL!
7
English
0000G12BYEQ̲metabo.indb 7
0000G12BYEQ̲metabo.indb 7
2020/06/15 14:18:14
2020/06/15 14:18:14
