AEROCET 532 Manual Rev B
Page 27
The following table lists the available commands:
Command Description
?
Help command
1
Report settings
2
Report all the data
3
Report the new data
4
Report the last record(s)
A
Network address command
C
Clear the data file
E
Stop sample
H
Help Menu
Q
Exit Terminal Mode
S
Start sample
X
Exit Terminal Mode
BL
Back Light (%)
CM
Count Mode: CM 0=Cumulative, CM 1=Differential
CU
Count Units: CU 0=CF, CU 1= /L, CU 2= TC, CU 3=M3
DS
Report data log channel descriptors
DT
Date / Time
ID
Location ID
LN
Get/Set the location name for a specific location index using LN i n,
where i
– Location Index (1 – 10); n – Location Name (Capitol Letters
and numbers only) (no symbols except spaces) (7 characters max)
MA
Modbus Address (1-247)
MM
Measure Mode MM 0=Counts, MM 1=Mass
NW
Network On/Off
OI
Output Interval OI 0=Off, OI 1=On
PR
Print File
QH
Report data record header
RQ
Report (ReQuest) data record readings
RV
Report Firmware Revision
RZ
Report Measurement Sizes
SB
Get/Set USB Baud Rate. 3=2400, 4=4800, 5=9600, 6=19200,
7=38400,8=57600,9=115200.
SH
Hold Time (0-3600)
SK
Set PM K Factors. K Factor range is 0.1-20.0. PM1=1, PM2.5=2,
PM4=3, PM7=4, PM10=5, TSP=6
SM
Sample Mode. SM 0=Single, SM 1=Continuous
SS
Serial Number
ST
Sample Time. ST 0=1-min, ST 1=2-min, ST 2=5-min, ST 3=10-min, ST
4=15-min, ST 5=30-min, ST 6=1-hour.
TU
Temperature Units. TU 0=C, TU 1=F
DISPTO
Manual Display Timeout. 0=None, 1=1-min, 2=5-min, 3=10-min.
