13
GB
IRL
AUS
USA
NZ
CDN
IND
Do not allow the device to remain under pressure and/or exposed directly to
sunlight. Make certain the device is not heated beyond the maximum operating
temperature
(
→
Table 1)
. Protect the device from frost.
Never blow through the nozzles or valves with your mouth.
Use only MESTO spare and accessory parts.
We cannot assume any liability resulting from the use of third-party parts.
Wear suitable protective equipment when working with hazardous substances.
When pumping, always observe the piston pressure gauge to ensure the maximum
spraying pressure is not exceeded
(
→
Table 1 below)
.
Before filling, after use and before maintenance work, allow the residual pressure in
the tank to dissipate completely
(
→
Section "After Use", Section 1)
.
Scope of delivery
Tank [1] with pump [2], hose [3] with discharge filter [6], shut-off valve [4], instructions for
use [5], carrying strap [7] and spray wand [8].
(Fig. 1)
You will find the illustrations referred to above in the front fold-out pages 3 – 5 of these
Instructions for Use.
Technical data
Type of device
PRIMER 3237P
PRIMER 3238P
Max. filling amount
5 l (1.1 gal)
8 l (1.8 gal)
Total contents
6.9 l (1.5 gal)
10 l (2.2 gal)
Max. spraying pressure
3 bar (43.5 psi)
Max. operating temperature
30 °C (86 °F)
40 °C (104 °F)
Weight when empty
1.5 kg (3.3 lb)
3 kg (6.6 lb)
Material of tank
polyethylene
Spray wand
plastic 48 cm (18.9 in)
Where device is carried
on the side
Technical residual quantity
< 0.04 l (< 0.01 gal)
Max. volume flow
1.0 l/min (0.22 gal/min)
Recoil force
< 5 N
Table 1
Assembly
1. Fasten the carrying strap [6] on the tank [1]
(Fig. 2)
2. Push the hose [3] with the discharge filter [6] into the tank and secure it with the cap nut
[9].
(Fig. 3)
3. Push the tube [3] into the shut-off valve [4] and secure it with the cap nut.
(Fig. 3)
4. Screw the spray wand [8] onto the shut-off valve [4]
(Fig. 3)
