Messoa SLI080, Руководство пользователя, Страница: 8 / 20

8
1. Introduction
Controls
Loosen the four screws securing the panel to ex-
pose the controls and make required adjustments.
Important: After setup, make sure to lock all four
screws tightly in sequence as indicated in the cau-
tion label after setup to ensure waterproofing.
1. Diffuser Position Control: Use the provided
hexagonal wrench to loosen the screw and
move the screw to desired position to adjust
the LED beam angles.
• 0: No diffuser to occupy over the LED.
• 1~4: Adjust the position of the diffuser - The higher the number, the greater
the angle of illumination. Actual illumination angle depends on the model.
2. DIP SW1
• Pin #1~3: To sync with the shutter speed of the camera.
Pin #1 Pin #2 Pin #3 Shutter Speed
OFF OFF OFF No allowed.
ON OFF OFF 1/250 (Default)
OFF ON OFF 1/500
OFF OFF ON 1/1K
• PIN #4: To turn on/off the RS-485 impedance. If you are chaining multiple
illuminators, set the last one as “ON” and the rest as “OFF”.
3. DIP SW2
• Pin #1~7: To set the ID of the illuminator when chaining multiple illumina-
tors.
ID Pin #1 Pin #2 Pin #3 Pin #4 Pin #5 Pin #6 Pin #7
000 OFF OFF OFF OFF OFF OFF OFF
001 ON OFF OFF OFF OFF OFF OFF
002 OFF ON OFF OFF OFF OFF OFF
~ ~ ~ ~ ~ ~ ~ ~
127 ON ON ON ON ON ON ON
• Pin #8: Set #8 to be ON to enforce the telemetry ON/OFF function of the il-
luminator.
2 4
3 1
CAUTION !
Please lock all four screws
tightly in order illustrated
after setup to ensure the
waterproof warranty.
A typical torque of 5-8
kgf-cm is suggested.
1 2 3 4
2 1
4
3 6
5 7 8
Sensitivity
Light Dark
LED Power
Lo Hi
ON
ON
0 (OFF)
3 (3/4 ON)
4 (ON)
2 (2/4 ON)
1 (1/4 ON)
Diffuser Position Control
SW1
SW2