10.3 B.C.G & PREDTMSP Control
1. Lens Mount (CS Mount) :
For installation of CS Mount lenses only.
2. Tripod Stand :
Application for camera mounting onto the camera holder. Effective for
general camera tripods.
3. Exposure Control :
Auto IRIS mode (two types of lens are appropriate for this function) :
B.C.G function :
DC IRIS lens :
Set the IRIS slide switch to the DC position and
When D/N MODE set to B.C.G mode, the camera will change to
adjust the LEVEL control on the side panel to
COLOUR MODE and B/W MODE manually according to a RJ-45
obtain a clear picture.
B.C.G commands.
Video IRIS lens :
Set the IRIS slide switch to the VIDEO position
and adjust the LEVEL and ALC controls on the
lens to obtain a clear picture.
Automatic Electronic Shutter ( AES ) :
Set the IRIS slide switch to the AES position to automatically adjust
the shutter speed according to the subjects brightness.
4. V-PHASE Adjustment
When using two cameras or more, the image on the monitor may roll
vertically when switching sources. This rolling can be minimized by
PDSP(PREDTMSP, Pre-determined Shutter Speed) function :
adjusting this controller.
According to a RJ-45 PDSP commands, the shutter speed
5. DC IRIS LEVEL Adjustment
will manually change to Pre-determined shutter speed which is set
If using a DC type auto-iris lens, you will need to set the LEVEL volume.
in OSD menu.
Turn counterclockwise (L) for a darker picture. Turn clockwise (H) for a
brighter picture.
6. Back-Focus Adjustment :
A. Back Focus Screw :
Loosen this screw before using the Focus
Adjustment and to maintain correct focus
afterwards ensure it is tightened.
B. Focus Adjustment :
Adjust this dial to obtain correct back-focus
whilst using a CS mount lens.
7. Menu / Set-up Buttons :
For menu access and adjustment.
8. Video Output Terminal (BNC) :
Used to give out the video signal. Connected to the video input terminal
of a monitor, switcher, etc. (to be terminated with 75 ohm impedance).
Note : SW1&SW2 symbolise electronic switching (PIR) or manual
switching (Voltage free contact).
- 4 -
- 13 -
H (OFF)
GND
OFF
L (ON)
GND
ON
Control Terminal
PREDTMSP
Pin 3
Pin 7
L (ON)
H (OFF)
GND
Black and White
H (OFF)
L (ON)
GND
Colour
H (OFF)
H (OFF)
GND
Auto
L (ON)
L (ON)
GND
5. PARTS NAMES & FUNCTIONS
Control Terminal
Image
B = Pin 6
C = Pin 4
G = Pin 5
Function
RJ-45
7
8
2
4
5
3
6
1
Pin
DATA + (RS-485)
GND
POWER(+5V)
2
1
DATA - (RS-485)
PREDTMSP
B/W
GND
C/L
3
6
4 5
7
8
( 1 )
( 3 )
( 4 )
( 2 )
GND
( 8 )
RJ45
( 6 )
( 5 )
Socket
Wall
( 7 )
SW1
Rear
SW2
C/L
AUTO
B/W
ON
OFF
GND