Wireless
FULL-HD
Manhole Zoom Camera
STV-4
MesSen Nord GmbH
21
5 Troubleshooting
Message: “Router/radio amplifier is not available. Please check the start-up
condition/battery of the radio amplifier. The PC must be connected to the
WLAN of the radio amplifier!”
-
Switch on the router by pressing the power button. Keep the button pressed
until the LED of the button lights. (See chapter 3.2) Make a wireless
connection to the router's WLAN. Restart the connection setup via the camera
selection.
Message: “The camera is not logged in to the router. Please wait the start-up
condition of the camera (approx. 60 sec.).”
-
Switch on the camera by pressing the power button. Observe the LED
switches. Very fast flashing (2x per second) indicates low batteries. Please
change the batteries to ensure correct functioning of the camera.
Message: “Camera is connected, video streaming has not yet been initialised
(requires about 60 sec. after switching on).”
-
The camera is still in start-up phase (Status-LED is fading). Try to start the
connection setup to the camera again in about 60 seconds, using the camera
selection buttons when the status LED is blinking. (See chapter 4.3)
Message: “Camera is connected, video streaming is not ready yet (requires
about 30 sec. more).”
-
The camera is still in start-up phase (Status-LED is fading). Try to start the
connection setup to the camera again in about 30 seconds, using the camera
selection buttons when the status LED is blinking. (See chapter 4.3)
“The camera displays a black image during video recording.”
-
No encoder/format selected for video storage. Please select a video encoder
with correct settings, according to chapter 4.2.
If necessary, you can contact us personally for support via the contact information
provided therein.
