8
2.
Place your finger on the rubber pads of the clip (make sure it is in the correct position), then
pinch your finger.
CAUTION:
Nails and light emitting diode should be on the same side.
3. Press the switch button on the front panel once.
4. Do not swing your finger and stay calm. Do not make any movements during the
measurement.
5. Get information directly from the screen.
6. The On button (see Rys. 2) has two functions:
a) When the device is turned off - pressing the button can open it.
b) When the device is turned on - a short press of the button can change the direction of the
screen.
10.
CLEANING AND DISINFECTION
• Turn off the device
before cleaning.
• Cle
an the surface of the device before use. First wipe the device with medical alcohol and
then allow it to air dry or clean with a dry, clean cloth.
• For
cleaning, use a soft, clean cloth dampened with equipment cleaner.
• The device c
annot be steam sterilized.
11.
SOLUTIONS OF EASY TROUBLES
SpO2 and pulse rate cannot be displayed normally.
Place your finger correctly and try again.
SpO2 and heart rate are not steadily displayed.
Place your finger correctly, try again, and stay calm.
The device cannot be turned off.
Remove the battery. Reinstall the batteries.
If the machine still does not turn off, contact your local service center.
The display suddenly turns off.
This is normal - after 5 seconds without use, the device automatically turns off or the battery
should be replaced.
12.
STANDARDIZED MARKINGS
Follow the user manual.