Mesa MAWS Series, Руководство по эксплуатации

Страница: 6 / 12

INTERIOR LIGHT
The interior light is controlled by a switch located on the top edge on the
inside of the door panel.
NOTE : Always remember to turn the light off before closing & locking
your safe or it will drain batteries. If batteries die when safe is locked, use
your override keys to gain access.
SAFE INSTALLATION
ADJUSTING & SECURING THE TELESCOPING BACK
1
Using 6 sets of Hardware C , attach the
middle section of the telescoping back
first. Keep screws loose enough so the
depth can be adjusted.
2
Using 6 sets of Hardware B , attach the
back section of the telescoping back first.
Keep screws loose enough so the depth can
be adjusted.
3
Now that both sections have been
attached, determine the maximum
depth available in your wall.
4
Adjust & secure both sections of the
telescoping back to the determined
depth.
Do not over tighten scews.
CHOOSING A LOCATION
IMPORTANT : Be sure to pick a wall free of plumbing pipes & electrical
wires. Use caution when cutting into drywall.
The wall safe is 14" wide & is designed to
fit between standard 16" center-to-center
studs.
NOTE : Most homes have wall framing construction of 2x4's &/or 2x6's
that are located 16" from center of stud to center of stud.
TOOLS REQUIRED FOR INSTALLATION
NOTE : Instructions shown are for wood framed wall installation.
PG.5
|
MAWS-SERIES ELECTRONIC LOCK INSTRUCTIONS
Tape Measure
Pencil
Drill
Dry-wall Saw or Jig Saw
Framing/T-square
Screwdriver [Philip's & flathead]
Flashlight
Stud Finder