12
DOOR SPEED SELECTION:
The “CyclonePro” opener has been designed to work with a wide range of garage doors with a total mass up to 286kg.
The CyclonePro can be set on NORMAL speed when operating doors with a total mass of less than 130Kg.
“The Protector System
TM
” must be used for all installations where the closing force as measured on the bottom of the
door is over 400 N (40 kgf).
When the CyclonePro is installed on doors with a total mass exceeding 130kg the operator should be set on SLOW
speed mode.
The “Protector System” must be installed when SLOW speed mode is selected.
Installers should ensure that the doors are installed in a compliant manner as per AS/NZS 60335-2-95.
TRAVEL SPEED:
There are two travel speeds available for this opener.
Factory default is set to the NORMAL speed.
TRAVEL SPEED: Manually selected:
The speed can be set manually if required, using the following method.
To activate the alternate speed:
PRESS and HOLD both the
UP
and
DOWN
arrows for 3 seconds.The courtesy lamp will flash once to confirm SLOW
speed and twice to confirm NORMAL speed.
To deactivate the selected speed:
Repeat the process above (toggle between the two settings).
PROGRAM THE TRAVEL SPEED
21
TEST THE SAFETY REVERSE SYSTEM
Procedure:
With door opened place a 40 mm obstacle (1) laid flat on the floor
under the garage door. Operate the door in the down direction. The door must
reverse off the obstacle. If the door stops on the obstacle, remove obstacle and
repeat Program the Limits and Force Steps, then repeat safety reverse test.
When the door reverses off the 40 mm obstacle, remove the obstacle and run the
opener through a complete travel cycle. Door must not reverse in closed position. If
it does, repeat Program the Limits and Force then repeat safety reverse test.
1
40mm
The safety reverse system test is important. Garage door must reverse on contact with a 40 mm obstacle
laid flat on the floor. Failure to properly adjust opener may result in serious personal injury from a closing
garage door. Repeat test once a month and adjust as needed.
20
Low Standby Mode (sub 1 watt) is activated by the factory to deliver the lowest possible standby power.
In this mode the External Accessories Power and the IR Beams are turned OFF when the door is closed and the courtesy light
is OFF. IR Beams operate normally in Low Standby mode.
At mains turn ON: Courtesy light flashes 2 times = Low Standby Mode
Courtesy light flashes 10 times = Normal Standby Mode
The Normal Standby Mode will need to be activated for External Accessories Power.
To Activate Normal Standby Mode:
Turn the mains power OFF.
PRESS and HOLD both the
UP
and
DOWN
arrows simultaneously.
Turn ON mains power while both the arrow buttons are still pressed.
Courtesy light comes on and after 5 seconds another 10 flashes.
Release the arrow buttons.
To Activate Low Standby Mode:
Turn the mains power OFF.
PRESS and HOLD both the
UP
and
DOWN
arrows simultaneously.
Turn ON mains power while both the arrow buttons are still pressed.
Courtesy light comes on and after 5 seconds another 1 flash.
Release the arrow buttons.
PROGRAM THE LOW STANDBY MODE (OPTIONAL)
22
Indicator LED
g.
n
e
