Merit MEGATOUCH FORCE Series, Инструкция по замене

Страница: 7 / 12

COPYRIGHT © 2008 MERIT ENTERTAINMENT
Continue connecting the DC jumper cable as
shown in Figure 7. For more detail, follow the
steps below:
•
Connect the 20-pin power supply connec-
tor to the motherboard (see Figure 4).
•
Connect the appropriate 4-pin connector
to the centronics power connector (see
Figure 3).
•
Connect the mating 4-pin connector to
J6 on the I/O board (see Figure 4).
•
Reconnect the hard drive power connec-
tor (see Figure 2) using the appropriate
4-pin connector.
•
FOR eVo ONLY : Locate 4-pin connector
on the DC jumper cable that connects with
the LED board and route this down to-
ward the access hole below the
motherboard (see Figure 2).
4. Replace the motherboard by sliding it
under the clamps on the left side of the
game, then lining up the two screw holes
on the right side of the board with the two
standoffs in the game. Replace the 2
screws that fasten the board to the game
(see Figure 2). Make sure no wires are
pinched after the motherboard is in place,
and make certain that the remaining 4-pin
connector coming from the new power
supply is visible and accessible.
CONNECT TO
MATING CONNECTOR
FROM POWER SUPPLY
CONNECT TO
MATING 4-PIN
HARD DRIVE
CONNECTOR
CONNECT TO
BILL ACCEPTOR
LED BOARD
(EVO ONLY)
CONNECT TO
MOTHERBOARD
CONNECT TO
J6 ON THE I/O BOARD
CONNECT TO
MATING 4-PIN
CENTRONICS
CONNECTOR
FIGURE 7 - DC JUMPER CABLE (EC0355-01) WITH CONNECTIONS
PM0684-02 FORCE POWER SUPPLY REPLACEMENT INSTRUCTIONS 5