Merit MEGATOUCH FORCE Series, Инструкция по замене, Страница: 6 / 12

COPYRIGHT © 2008 MERIT ENTERTAINMENT
Power Supply Installation
NOTE: The replacement power supply may
be slightly smaller in size than the power sup-
ply that was in your unit. Because of this, ad-
ditional foam tape may need to be added to
the power supply mounting bracket. If there is
already a double layer of foam tape on the
bracket, you do not need to install additional
tape. If there is only a single layer of tape,
and the new power supply isn’t seated cor-
rectly, follow the guide in Figure 6 below to
properly install the provided tape on top of
the existing tape.
PROVIDED
FOAM TAPE
EXISTING
FOAM TAPE
1. Install the new power supply by placing it
in the unit and securing it with the screws
and bracket that held the old power sup-
ply (see Figure 5). Be sure that the power
supply is installed with the IEC connector
on the top-left.
2. Replace the twist clamp around the larger
set of wires that will run to the
motherboard and I/O board, then reinstall
the standoff (see Figure 5).
3. Attach the 20-pin connector on the pro-
vided DC jumper cable (EC0355) to the
20-pin mating connector coming from the
power supply (see Figure 7).
FIGURE 6 - FOAM TAPE INSTALLATION ON POWER SUPPLY MOUNTING BRACKET
4 FORCE POWER SUPPLY REPLACEMENT INSTRUCTIONS PM0684-02