Site Preparation
In determining the location for your
Megatouch video game, consideration must
be given to a suitable, grounded electrical
outlet. Since the game is a computerized
device, it should have a separate circuit if at
all possible. If a separate circuit is not avail-
able, care should be taken to provide a clean
and constant voltage. As a basic guideline,
never connect the unit to a circuit that also
supplies power to freezers, coolers or other
high power consuming and electrical noise
generating equipment. Place the game in a
location where nothing will interfere with
proper ventilation. The game should not be
exposed to any dripping or splashing liq-
uids.
NOTE: After turning off the unit, wait
60 seconds before turning the game
back on. This will allow the game to
properly reset.
Setting up your Megatouch Game
1.
Remove the game from the carton.
2.
Open the additional box and use the
instructions provided to attach the drink
arms to the game.
3.
Attach the power cord to the back of
the game near the ON/OFF switch. Plug
the game into a standard AC outlet.
4.
Turn the power switch at the back of
the game to ON and wait for it to go
through its boot-up sequence. At the
completion of the boot-up sequence,
the game will display the Player Menu.
5.
The machine has been preset at the
factory and therefore should not need
to be adjusted; however, it is recom-
mended that the screen be calibrated
(see Screen Calibration) and the coin
or bill acceptor(s) be tested.
6.
There are many custom settings avail-
able for the game. To customize the
settings, follow the instructions begin-
ning with the Main Menu section in this
manual.
Game Description
The game is housed in a 61.25” upright cabi-
net. It should be located on a sturdy, level
surface. The bottom of the cabinet has four
leg levellers to make any necessary adjust-
ments. When the game is properly adjusted,
it should remain stable.
There are 4 key-locked compartments: the
top bezel, monitor bezel, bottom door, and
the cash box door.
An additional keyhole is
located on the right side of the game for the
Refill Key. See the Hopper Refill section of
this manual for more information.
Three modes are available for gameplay:
Amusement, Money Shoot/Skill With Prize
(S.W.P.), and Tournament (TournaCHAMP
and Championship Edition). The default set-
ting is S.W.P. only. TournaCHAMP play re-
quires a modem. Championship Edition is
available with the purchase of an additional
kit (part number KUV-113-003-01).
The SETUP and CALIBRATE buttons are lo-
cated on the monitor control board above
the LCD touchscreen (see Figure 1). To
access the monitor control board, unlock the
left and right locks on the top bezel. Lift the
bezel. The screen will go blank. Press the
SETUP button and a keypad will display on-
screen. Enter your PIN code (default is 4777)
to load the Main Menu Screen or turn the
Refill Key. An incorrect PIN will clear the
keypad. After 3 incorrect attempts, entry to
SETUP is not permitted. Close and open the
top bezel to reset the keypad.
See General Care and Maintenance for
calibration instructions.
NOTE: To close the bezel, lift it, then
push down on the yellow rubber
bracket covers to move the brackets
from the locking channel. Lower the
bezel to close. Make sure all doors are
locked after closing the doors.
COPYRIGHT © 2005 MERIT INDUSTRIES, INC.
1 MONEY SHOOT OWNER’S MANUAL PM0519-03
