Meridian Bulk Seed Tender Seed Express 225RST, Руководство оператора

Страница: 36 / 68

36
9. STORAGE
9.1 GENERAL INFORMATION
After planting or when the machine will not be
used for a period of time, completely inspect
all major systems of the seed tender. Replace
or repair any worn or damaged components to
prevent unnecessary downtime at the beginning of
the next season.
IMPORTANT
To prevent component damage, store the seed
tender in a dry, level area. If the seed tender is not
attached to a trailer, support the frame with planks
to raise the unit off the ground.
9.2 PLACING IN STORAGE
CAUTION
PERSONAL INJURY HAZARD
Store the unit in an area away from
human activity. To prevent the possibility
of serious injury, do not permit children
to play on or around the stored machine.
1. Remove all seed from the seed tender.
2. Place the gasoline engine fuel valve in the
OFF position.
3. Thoroughly wash the machine with a pressure
washer or water hose to remove all dirt, mud,
or debris.
4. Inspect rotating parts for entangled material.
Remove all entangled materials.
5. Check the condition of the auger and delivery
spout. Replace or adjust, as required.
6. Check the condition of the centrifugal clutch
reduction case, pulleys, idlers, and drive belt.
Replace or adjust, as required.
7. Touch up paint nicks and scratches to prevent
rusting.
8. Remove the ignition key and store in a secure
place.
9. Remove the battery and store it in a cool, dry
area on wooden blocks or a wooden pallet.
Charge it monthly to maintain an adequate
charge.
10. It is best to store the machine inside and if that
is not possible, cover with a waterproof tarp
and tie down securely.
11. Inspect, clean, and lubricate the auger tube
hinge.
12. Cover the unit with a tarp, if desired.
9.3 REMOVING FROM STORAGE
When removing the machine from storage, follow
this procedure:
1. Remove the tarp, if covered.
2. Install and connect the battery.
3. Review and follow the Pre-Operation
Checklist.
4. Review and follow the Service Checks in the
Maintenance section.
IMPORTANT
If the machine has been stored for more than
twelve months, warm the engine by running it
for two to three minutes and then drain the oil.
Change the oil while the oil is warm to remove any
condensation. Refer to the Change Engine and
Reduction Case Oil section in the Maintenance
section.