Customising the analogue controller
20
The 502 Analogue Controller allows you to program the level of
each source independently, to suit your other equipment, so that
when you switch between sources the volume stays the same.
When you are programming levels the analogue controller
operates as a preamplifier with a fixed volume setting equivalent
to 65. This level is chosen to be comfortably loud on average
sources. You can switch between sources and adjust the
relevant input levels to achieve the setting you want.
You can increase the sensitivity of any source by up to 30 steps
of 1dB. The loudest source, usually CD, should therefore be
chosen as the reference.
Programming levels
To balance input levels
●
Switch off any power amplifiers that are connected to the
analogue controller.
●
Switch off the analogue controller, using the power switch on
the back panel.
●
Switch on the power again while holding down the Mute key
on the front panel.
The display will show:
Gain Set
●
Release the Mute key.
The display will show the
normal standby condition:
.
●
Select the source that sounds loudest and make it your
reference.
●
Switch to another source in the usual way.
Содержание Analogue Controller 502
Страница 1: ...Meridian 502 Analogue Controller u s e r g u i d e ...
Страница 38: ...Setting up the analogue controller 34 ...
