Meridian Analogue Controller 502, Руководство пользователя

Страница: 13 / 40

Using the analogue controller
9
Selecting a source
During normal use the analogue controller should be left in the
standby state. This uses a negligible amount of electricity, but
ensures that the components of the analogue controller operate
at maximum efficiency from the moment you start.
If you are not going to use the analogue controller for a period of
several days you should switch the unit completely off, at the
back panel, and disconnect it from the AC power supply.
To switch on from standby
●
Press Source (front panel), or select a source by pressing the
appropriate source key on the remote.
If the 502 Analogue Controller is part of a Meridian system, it will
automatically switch on any other unit in the system.
To select a source
●
Press Source (front panel) until the display shows the source
you require, or press the appropriate source key on the
remote.
The display shows the source, and
volume setting; for example:
CD 65
By default, the following seven sources are available:
Source Input
CD A5 (balanced)
Radio A3
LP A1
TV A4
Tape1 A2
Tape2 A7 (balanced)
CDR A6 (balanced)
To switch to standby
●
Press Off on the front panel or the remote.
The display will show:
.
If you have other Meridian 500 Series equipment connected to
the analogue controller, these units will also switch to standby.