Meridian 400 SLD, Руководство оператора

Страница: 56 / 84

56
12. TROUBLESHOOTING
12.1 TROUBLESHOOTING CHART
PROBLEM CAUSE SOLUTION
Engine will not start. No fuel. Fill the fuel tank.
Low engine oil. Fill the crankcase with oil.
Cold engine. Open choke.
Ignition key switch off. Turn ignition key switch on.
Battery dead. Recharge or replace battery.
Engine problem. Refer to engine manual.
Conveyor belt will not start. No power. Start engine and increase speed above
1400 RPM.
Drive motor coupling. Repair or replace coupling.
Belt tension. Increase belt tension.
No hydraulic oil. Check oil level.
Electrical or hydraulic functions
are not working properly.
Transmitter power is OFF. Turn Power ON.
Receiver power is OFF. Turn Power ON.
Battery cable or battery. Check battery cable and make sure battery
is fully charged.
Error in the control system. Check LED Error Code light.
Improper ground. Check for proper grounding electrical
circuit.
Hydraulic valve or motor. Ensure hydraulic pump is working properly
and hydraulic tank is filled with oil.
Intermittent function. Check receiver antenna for damage and
proper connection.
Loose connector at the valve coil.
12.2 CONTROL PANEL INDICATOR
LEDS
12.2.1 Error Code Outputs
The receiver module can identify problems with
the system in the form of an error code. Check
red indicator light (11) on the receiver to diagnose
system problems.
Each of the outputs from the receiver module is
designed with built-in short circuit and overload
protection. The outputs can also detect a no -load
or broken wire condition.
These error conditions are indicated by the red
LED indicator on the receiver module or the
HISTOGRAM page on the optional Palm Pilot™.
Refer to the Error Code Chart for explanation
of the error codes. Green LED indicator light
(9) will blink on the receiver during normal
communication.
The ON/OFF outputs will indicate an error under
no load or broken wire status if NOT activated,
and will detect a short if activated.