Meridian 400 SLD, Руководство оператора

Страница: 28 / 84

28
5.4 WIRELESS REMOTE
TRANSMITTER
Each radio remote transmitter is designed to
operate with a unique radio ID code and RF
channel sequence. Each receiver is programmed
to respond only to the remote transmitter with the
correct ID code/RF channel sequence for which
it is set. This feature allows multiple systems to
work in close proximity to one another without
interference.
If the remote transmitter goes out of range for
more than two seconds, all latched outputs will
turn off as a safety feature.
In the event that a remote transmitter becomes
damaged and a new one is needed, the receiver
can be reprogrammed to respond to the new
remote transmitter. Refer to the 10.1.2 Remote
Control Transmitter and Receiver Synchronization
section in the Maintenance section of this manual.
All of the normal functions of the seed tender can
be controlled by the remote transmitter.
5.4.1 Functions of Keypad Buttons
Use the buttons on the keypad to operate the
desired functions of the seed tender.
POWER (1)
Press Power button (1) to turn remote transmitter
ON. Press and hold the button to turn it OFF.
To save battery life, the remote transmitter will
automatically turn off when it is idle (no functions
are used) for a period greater than 15 minutes.
Press the POWER button to turn the unit ON.
NOTE: The remote transmitter will NOT
automatically shut off as long as the receiver has
power applied to it.
ENG STOP (2)
Press Engine Stop button to turn OFF engine.
CONV (3)
The Conveyor button starts and stops the
conveyor belt. Press the INC button to start the
conveyor. Press STOP button to stop conveyor.
GATE 1 (4)
The Slide Gate 1 buttons open and close the slide
gate at the bottom of compartment 1. Press the
OPEN button to open the slide gate, and press
the CLOSE button to close the slide gate. The
opening can be varied to provide the desired flow
rate of seed onto the conveyor belt.
CONV (5)
This Conveyor button positions the conveyor to the
right or left. Press the LEFT button to position the
conveyor towards the front of the unit. Press the
RIGHT button to position the conveyor towards the
rear of the unit.