Mercury Quicksilver 200 Tendy Slatted, Руководство пользователя

Страница: 58 / 63

For the best results when gluing, the relative humidity should be less than 60%,
ambient air temperature should be between 18 °C to 25 °C (65 °F to 77 °F),
and not in direct sunlight.
Cut out a patch large enough to overlap the damaged area by 38 mm (1.5 in.)
on all sides. Center the patch over the damaged area, and trace the outline of
the patch with a pencil. Apply masking tape around the perimeter of the
outlined patch area to ensure a tight and clean glue line.
Clean the patch area on the boat as well as the back side of the patch with
methyl ethyl ketone patching solvent and cleaner. Do not allow the solvent to
contact your skin. After applying the solvent, you will notice that the area will
become tacky. This tackiness ensures good glue adhesion.
NONCATALYST GLUE (EMERGENCY REPAIRS ONLY)
Follow the directions listed on the product.
TWO-PART CATALYST ADHESIVE
Mix a batch of adhesive according to the directions provided with the adhesive.
Do not allow the adhesive to contact your skin. When the adhesive is fully
mixed, it must sit for a short time to activate the catalyst. Failure to allow
sufficient time for the catalyst to alter the adhesive compounds, will cause poor
fabric adhesion.
Apply three thin layers of adhesive with a short bristle brush, in a circular
pattern on both the back side of the patch and the patch area on the boat.
Allow each layer to dry for 5–10 minutes before applying the next layer. After
applying the third layer, wait 5–10 minutes and then apply the patch to the
prepared area and press down firmly. Using a smooth object (a back of a
tablespoon works well), force out any air bubbles that may have been trapped
under the patch, working from the center of the patch to the outside.
After removing the masking tape, place a 4–5 pound weight onto the patch and
allow 24 hours drying time before pressurizing the repaired air chamber.
REPAIRS
50
eng