HDD Off After
Default: Disable
You can set this item to a selection of timeouts from 1 to 15 minutes. The hard
disk drive will power down if the selected timeout passes without any activity on
the hard disk.
IRQ [3-7,9-15], NMI
Default: Enabled
You can set this item to enabled if you want the system to wake up from suspend
or standby mode when activity is detected on a device using any of these IRQ
addresses.
IRQ 8 Break Suspend
Default: Disabled
You can set this item to enabled if you want the system to wake up from suspend
mode when activity is detected on a device using IRQ 8.
Power Button Override
Default: Instant Off
Under ACPI (Advanced Configuration and Power management Interface) you
can create a software power down. In a software power down, the system can be
resumed by Wake Up Alarms. This item lets you install a software power down
that is controlled by the normal power button on your system. If the item is set to
Instant-Off, then the power button causes a software power down. If the item is
set to Delay 4 Sec. Then you have to hold the power button down for four
seconds to cause a software power down.
Ring/WOL/WOM WakeUp/PwrOn
Default: Enabled
If this item is enabled, it allows the system to resume from a software
powerdown or a power-saving mode whenever there is an incoming call to an
installed fax/modem or network adapter. You might have to connect the
fax/modem and /or network adapter to a mainboard Wake On Modem and Wake
On LAN connector for this feature to work.
KB Power ON Password
Default: Enter
This item can be used to prompt the used for a password when the system
power is resumed by keyboard action.
Power Up by Alarm
Default: Disabled
If this item is Enabled, it allows you to set a date and time alarm that will
automatically resume the system from a software power down. When you enable
this feature, new setup items appear to let you set the alarm. Date (of Month)
Alarm lets you select a day from 1 to 31. Time Alarm lets you select a time for
the alarm in hours, minutes, and seconds.
53
