background image

1. Idle Speeds

Maintains the existing trim position.

2. Acceleration (hole shot)

Tucks the engine under to minimize 
bow rise and improve time-to-plane.

Resume functionality

If the boat operator overrides Active Trim system at planing 
speeds using the trim button or exceeds 50 mph (80 kph), the 
system will stop controlling. Active Trim will resume automatically 
under the following conditions:

•  Override occurred above 50 mph (80 kph) and the boat operator 

then decelerates below 50 mph (80 kph).

•  Override occurred above 80% of rated engine RPM and the boat 

operator then decelerates below 80% of rated engine RPM.

•  Override occurred in cruising speed range and then the boat 

operator decelerates to idle. Active Trim will become active on the 

next acceleration.

Shallow water operation

Active Trim cannot detect water depth and will not trim up 

automatically in shallow water. The boat operator will need to 

override Active Trim by trimming the engine manually or pressing 

the OFF button.

•  If the boat operator trims above 50% trim position, the system will 

remain in the standby / manual state and will not trim the engine 

down automatically.

•  Automatic control can be resumed by pressing On/Resume button.

Built-in GPS

This device includes a built-in GPS antenna used to determine 
vessel speed. The GPS has three start-up modes:

 COLD START

 – If vessel battery power was turned off (using battery 

switch), GPS will take between 30-60 seconds to acquire a signal.

• 

WARM START -

 If vessel battery power has been maintained 

since last shutdown, GPS will acquire a signal in approximately 30 

seconds.

• 

HOT START -

 If vessel has been keyed off for less than eight hours, 

the GPS will acquire a signal in less than 10 seconds.

Active Trim system will not automatically control trim until GPS 
has acquired a signal.
System Status LED flashing red light may indicate no GPS signal 
has been acquired.

The Active Trim system has four modes of operation. 

At boat startup, Active Trim resumes on/off state from the 

previous shut down. For example, if Active Trim was on at 

previous shut down, it will be on at next start-up.

3. Planing Speeds

Progressively trims the engine based 
on GPS speed to maintain the most 
efficient running attitude.

4. Override

When the boat operator uses manual 
trim, the Active Trim system is 
immediately overridden, returning 
full control to the operator. 

How it works

What you need to know

Refer to your owner’s manual for 

more detailed instructions. 

Отзывы: