Mercury 250 Jet, Руководство по установке

Страница: 7 / 46

250 HP JET DRIVE INSTALLATION MANUAL
Page 7
90-10240040 DECEMBER 2003
Remote Control and Cables
The remote control must provide the following required features:
•
Start in gear protection
•
Neutral RPM limit at 2,000 RPM
Note: This applies to dual lever remote controls as well as single lever remote controls.
•
High strength mechanism to accommodate loads transmitted to the remote control
•
Shift cable travel of 76 mm 3 mm) (3 in. 1/8 in.)
•
Ability to use 40 series shift cable
The remote control must meet the above criteria as well as the design criteria outlined in
the ABYC manual pertaining to Mini-Jet Boats (Standard P-23).
SHIFT CABLE
The shift cable to be used MUST MEET the following criteria:
•
40-Series Cable
•
40 Series bulkhead fitting at output end
•
Allow for a minimum of 76 mm (3 iin.) of travel.
•
A means of attaching and locking the cable to the shift cable bracket (provided).
•
Cable end at pump must allow for a 1/4 inch clevis pin and cotter pin (all provided) to
connect cable to the reverse gate.
•
Protected against water intrusion and/or corrosion as the cable end (at the pump) is sub-
mersed in water with the boat at rest.
The shift cable end (at the pump) is submersed in water. It should be sealed against water
intrusion, protected against corrosion and be able to withstand the shift loads imparted on
it by the reverse gate.
Follow shift cable adjustment procedure for proper adjustment.
THROTTLE CABLE
The throttle cable must have one end compatible with the control box. The other end must
have Mercury style connectors.
Follow throttle cable adjustment procedures for proper adjustment.