Erasing personal code
1. Enter the factory set 5–digit code.
2. Within five seconds, press the 1
•
2 on the keypad and release.
3. Press and hold the 1
•
2 for two seconds. This must be done within
five seconds of completing Step 2.
All personal codes are now erased and only the factory set 5–digit code
will work.
Anti-scan feature
If the wrong code has been entered seven times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
•
one minute of keypad inactivity.
•
pressing the
control on the remote entry transmitter portion of
your Integrated Keyhead Transmitter.
•
the ignition is turned on.
Unlocking and locking the doors using keyless entry
To unlock the driver’s door,
enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate.
Note:
If the two-stage unlocking
feature is disabled, all doors will unlock; for more information regarding
two-stage unlocking, refer to the
Unlocking the doors/Two stage unlock
section earlier in this chapter.
To unlock all doors,
enter the factory set code or your personal code,
then press the 3
•
4 control within five seconds.
To lock all doors,
press the 7
•
8 and the 9
•
0 at the same time (with
the driver’s door closed). You
do not
need to enter the keypad code
first.
SECURILOCK™ PASSIVE ANTI-THEFT SYSTEM
SecuriLock™ passive anti-theft system is an engine immobilization
system. This system is designed to help prevent the engine from being
started unless a
coded Integrated Keyhead Transmitter (IKT)
programmed to your vehicle
is used. The use of the wrong type of
coded key may lead to a “no-start” condition.
Your vehicle comes with two coded Integrated Keyhead Transmitters;
additional coded IKTs may be purchased from your authorized dealer.
2009 Sable
(mgo)
Owners Guide, 1st Printing
USA
(fus)
Locks and Security
141
