Mercury 100 FourStroke, Руководство по обслуживанию

Страница: 257 / 574

90-830234R3 DECEMBER 1997 POWERHEAD - 4-45
Cylinder Cover, Exhaust Divider Plate
and Exhaust Cover
•
Thoroughly clean cylinder cover and gasket sur-
faces.
•
Inspect cylinder cover. Check for cracks which
could cause water leakage.
•
Replace cylinder cover as necessary.
•
Thoroughly clean gasket surfaces of exhaust di-
vider plate and exhaust manifold cover.
•
Inspect exhaust divider plate and exhaust
manifold cover for grooves, cracks or distortion
that could cause leakage. Replace parts as
necessary.
a
b
c
a - Cylinder Cover
b - Divider Plate
c - Exhaust Cover
Thermostat
Wash thermostat with clean water. Using a thermo-
stat tester, similar to the one shown, test thermostat
as follows:
•
Open thermostat valve, then insert a thread be-
tween valve and thermostat body. Allow valve to
close against thread.
•
Suspend thermostat (from thread) and thermom-
eter inside tester so that neither touches the con-
tainer. Bottom of thermometer must be even with
bottom of thermostat to obtain correct thermostat
opening.
•
Fill thermostat tester with water to cover
thermostat.
•
Plug tester into electrical outlet.
•
Observe temperature at which thermostat begins
to open. Thermostat will drop off thread when it
starts to open. Thermostat must begin to open
when temperature reaches 5
F (3 C) above
designated stamping on bottom of thermostat.
•
Continue to heat water until thermostat is com-
pletely open.
•
Unplug tester unit.
•
Replace thermostat, if it fails to open at the speci-
fied temperature, or if it does not fully open.
51087