Mercury 100 EFI, Руководство пользователя

Страница: 33 / 87

FEATURES AND CONTROLS
27
a
c
b
20760
a - Trim switch
b - Tilt range
c - Trim range
POWER TRIM OPERATION
With most boats, operating around the middle of the trim range will give satisfactory results. However, to take
full advantage of the trimming capability there may be times when you choose to trim your outboard all the way
in or out. Along with an improvement in some performance aspects comes a greater responsibility for the
operator, and this is being aware of some potential control hazards.
The most significant control hazard is a pull or torque that can be felt on the steering wheel or tiller handle. This
steering torque results from the outboard being trimmed so that the propeller shaft is not parallel to the water
surface.
!
WARNING
Avoid possible serious injury or death. When the outboard is trimmed in or out beyond a neutral steering
condition, a pull on the steering wheel or tiller handle in either direction may result. Failure to keep a continuous
firm grip on the steering wheel or tiller handle when this condition exists can result in loss of boat control as
the outboard can turn freely. The boat can now spin out or go into a very tight maximum turn which, if
unexpected, can result in occupants being thrown within the boat or out of the boat.
Consider the following lists carefully.
1. Trimming In or Down Can:
• Lower the bow.
• Result in quicker planing off, especially with a heavy load or a stern heavy boat.
• Generally improve the ride in choppy water.
• Increase steering torque or pull to the right (with the normal right hand rotation propeller).
• In excess can lower the bow of some boats to a point where they begin to plow with their bow in the
water while on plane. This can result in an unexpected turn in either direction (called bow steering
or over-steering) if any turn is attempted, or if a significant wave is encountered.
!
WARNING
Avoid possible serious injury or death. Adjust outboard to an intermediate trim position as soon as boat is
on plane to avoid possible ejection due to boat spin out. Do not attempt to turn boat when on plane if
outboard is trimmed extremely in or down and there is a pull on the steering wheel or tiller handle.