L Front and Rear Shaft and
Bearings
(Figure 8)
1.
Remove outer case (Section A), and conveyor
chain (Section K).
2.
To remove front shaft bearings:
first
remove the bearing retainers on both sides of
unit.
3.
With retainers removed, slide bearing out (with
shaft if necessary). Note proper location of
the spacer washers on the front bearing
retainer studs.
4.
Replace bearings (and front shaft if neces-
sary).
5
.
To remove rear shaft bearings:
remove
drive chain (Section H), and conveyor shaft
sprocket (Section J).
6.
Remove bearing retainer brackets at both
sides of unit and slide bearings out. Shaft can
be replaced at this time if needed. Note
proper orientation of hex head spacers.
7.
Replace bearings (and rear shaft if neces-
sary), shaft sprockets and drive chain (Section
H).
8.
Replace conveyor chain (Section K).
M Power-On Light
1.
With control panel removed (Section A), disconnect wire
leads from back of light.
2.
Press spring loaded tabs on back of light and push light
through front of panel.
3.
Insert new light from front of panel and snap into place.
4.
Re-attach wire leads. (Refer to appropriate wiring dia-
gram)
5
CONTROL PANEL FRONT VIEW
CONTROL PANEL REAR VIEW
Содержание RT-2AR
Страница 6: ...6 ...
Страница 7: ...7 ...
Страница 8: ...8 1111 N Hadley Rd Fort Wayne In 46804 Tel 800 701 2992 Fax 260 436 0735 www mercosavory com ...
