Please retain product label and instructions for future reference
P 7
Step 11
Parts needed - No. 6 QTY 2
No. 7 QTY 2
No. 8 QTY 2
No. 34 QTY 1
Roll out the Felt (
No. 34
) and use the Roof Panels
(
No. 6, 7 & 8
) as shown in the illustration so you
can accuartely cut the felt before fitting.
Leave a 100mm space between each panel and
cut through the centre to create 50mm overhang
for each strip. Make sure that there is a 50mm
overhang under each panel
Measure and cut four strips of felt (
No. 34
) at
1600x200mm.
Measure and cut one full width strip of felt (
No.
34
) at 1400mm long.
Once all the pieces of felt have been cut keep
these to one side whilst you construct the roof.
1600x200mm
QTY 4
1400mm
QTY 1
100mm gap between
each panel
100mm gap between
each panel
50mm overhang
below each panel
50mm overhang
below each panel
50mm overhang
below each panel
50mm overhang
below each panel
1
2
3
4
34
HANDLE
WITH CARE
1
2
3
4
Step 12
Parts needed - No. 12 QTY 1
No. 13 QTY 3
Pre drill holes in the underside of
Roof Bearer A
(No. 12)
and all 3 of
the Roof Bearer B
(No. 13)
parts
with an offset position of
40mm
from each of the pointed ends in
the centre of the bearers. These
holes are going to later recieve
60mm screws.
Pre drill
hole
12
13
13
12
SIDE VIEW
UNDERNEATH VIEW
SIDE VIEW
UNDERNEATH VIEW
40mm
Step 13
Parts needed - No. 6 QTY 2
Place both 6Ft Roof Panels
(No. 6)
on the floor and measure
195mm
from the top of the Framing and
mark the distance on the vertical
framing with a line.
Repeat this step for both roof 6Ft
Roof Panels
(No. 6)
.
6
195mm
Содержание 03DTMBHP0806RFP-V1
Страница 17: ...2 1 3 4...
Страница 18: ...1 2 REGISTER FOR YOUR ANTI ROT GUARANTEE TODAY PLEASE SCAN HERE...