Mercedes-Benz GLS 2023, Руководство оператора

Страница: 256 / 538

#
Apply the electric parking brake.
#
Shift the transmission to position
j
(
/
page 195).
#
Pull switch 1 in the cargo compartment trim
briefly.
Indicator lamp 2 flashes until the vehicle has
been lowered.
The vehicle is lowered at the rear axle by
approx. 1.5 in (40 mm). When the vehicle has
been lowered, indicator lamp 2 remains lit.
Lowering is interrupted in the following situations:
R
a vehicle door is opened.
R
switch 1 is pulled again.
R
the vehicle is being driven faster than 1.2 mph
(2 km/h).
%
The vehicle is automatically set to the level of
the selected drive program if you drive at
speeds greater than 1.2 mph (2 km/h).
If indicator lamp 2 flashes twice and the rear of
the vehicle does not lower:
#
Make sure that the requirements are met.
%
Lowering the rear of the vehicle allows the
vehicle to be loaded more easily. Observe the
notes on loading the vehicle when doing this
(
/
page 125).
Raising the rear of the vehicle
#
Check if the battery is sufficiently charged. If
necessary, start the engine.
#
Pull switch 1 briefly.
Indicator lamp 2 goes out.
The vehicle will be raised to the currently
selected level.
%
The vehicle is automatically set to the level of
the selected drive program if you drive at
speeds greater than 1.2 mph (2 km/h).
If the vehicle cannot be raised:
#
Ensure that the battery is sufficiently charged;
if necessary, start the engine.
The raising process continues.
E-ACTIVE BODY CONTROL
Function of E-ACTIVE BODY CONTROL
* NOTE Mercedes-AMG vehicles
#
Observe the notes in the Supplement.
You could otherwise fail to recognize
dangers.
E-ACTIVE BODY CONTROL is an electrohydraulic
suspension system with variable damping for
improved driving comfort. The all-round level con-
trol system ensures the best possible suspension
and constant ground clearance, even with a laden
vehicle. When driving at speed, the vehicle is low-
ered automatically to improve driving safety and
to reduce fuel consumption. The suspension set-
ting is adjusted depending on the road surface,
vehicle load and the drive program selected.
The ROAD SURFACE SCAN function detects areas
of unevenness in the road before you drive over
them by means of a multifunction camera. This
reduces chassis movements.
254 Driving and parking