Mercedes-Benz E-Class Wagon 2019, Руководство оператора

Страница: 422 / 538

Removing and installing hub caps
Requirements:
R
The vehicle is prepared for a wheel change
(
/
page 419).
Plastic hub cap
#
To remove: turn the center cover of the hub
cap counter-clockwise and remove the hub
cap.
#
To install: make sure that the center cover of
the hub cap is turned counter-clockwise.
#
Position the hub cap and turn the center
cover clockwise until the hub cap engages
physically and audibly.
Aluminum hub cap
#
To remove: position socket 2 on hub cap
1 .
% The socket can be found in the tire-change
tool kit.
#
Position wheel wrench 3 on socket 2 .
#
Using wheel wrench 3 , turn hub cap 1
counter-clockwise and remove it.
#
To install: position hub cap 1 and turn until
it is completely flush with the wheel.
#
Position socket 2 on hub cap 1 .
#
Attach wheel wrench 3 to socket 2 and
tighten the hub cap clockwise.
Specified tightening torque: 18 lb-ft
(25 Nm).
Raising the vehicle when changing a wheel
Requirements:
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
/
page 419).
R
The hub caps have been removed
(
/
page 420).
Important notes on using the jack:
R
Use only the vehicle-specific jack that has
been tested and approved by Mercedes-Benz
to raise the vehicle.
R
The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
420 Wheels and tires