Mercedes-Benz E 350 BlueEFFICIENCY Cabriolet, Руководство оператора

Страница: 289 / 372

i Canada only:
This device complies with the RSS-210
Rules of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
IC: 279B-HMIHL4
Programming
Programming buttons
G
WARNING
Only press the button on the integrated
garage door opener if there are no persons or
objects present within the sweep of the
garage door. Persons could otherwise be
injured as the door moves.
Integrated garage door opener on the rear-view
mirror
Garage door remote control
A
is not part of
the integrated garage door opener.
X
Before programming for the first time, clear
the memory of the integrated garage door
opener (
Y
page 289).
X
Turn the SmartKey to position
2 in the
ignition lock.
X
Press and hold one of buttons
;
to
?
on
the integrated garage door opener.
After a short time, indicator lamp
:
lights
up yellow.
i Indicator lamp
:
lights up yellow as soon
as button
;
,
=
or
?
is programmed for
the first time. If the selected button has
already been programmed, indicator
lamp
:
will only light up yellow after ten
seconds have elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
Point garage door remote control
A
towards buttons
;
to
?
on the rear-view
mirror at a distance of 2 to 8 inches (5 to
20 cm).
i
The required distance between remote
control
A
and the integrated garage door
opener depends on the garage door drive
system. Several attempts might be
necessary. You should test every position
for at least 25 seconds before trying
another position.
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
If indicator lamp
:
lights up green or
flashes, then programming has been
successful.
X
Release button
B
on remote control
A
for
the garage door drive system.
X
If indicator lamp
:
lights up red: repeat
the programming procedure for the
corresponding button on the rear-view
mirror. When doing so, vary the distance
between remote control
A
and the rear-
view mirror.
i If the indicator lamp flashes green after
successful programming, the garage door
system is using a rolling code. After
programming, you must synchronize the
garage door opener integrated in the rear-
view mirror with the receiver of the garage
door system.
Features
287
Stowage and features
Z