Mercedes-Benz CLS 2011, Руководство пользователя

Страница: 218 / 389

R
the Off-road program is activated (vehicles
without the ON&OFFROAD package).
R
Off-road program 1 or 2 is activated (vehi-
cles with the ON&OFFROAD package).
R
the LOW RANGE off-road gear is activated
(vehicles with the ON&OFFROAD package).
R
a loss of tyre pressure or a defective tyre is
detected.
Activating Active Blind Spot Assist
X
On vehicles without a navigation system,
make sure that the Becker
®
MAP PILOT is
connected; see the separate operating
instructions for Audio 20.
X
Make sure that the radar sensor system
(
Y
page 249) and Active Blind Spot Assist
(
Y
page 245) are activated in the on-board
computer.
X
Turn the key to position 2 in the ignition
lock.
Warning lamps : light up red in the exte-
rior mirrors for approximately 1.5 seconds
and then turn yellow.
Trailer towing
If you attach a trailer, make sure that you have
correctly established the electrical connec-
tion. This can be accomplished by checking
the trailer lighting. Active Blind Spot Assist is
then deactivated. The indicator lamp lights up
yellow in the exterior mirrors and the Active
Blind Spot Assist currently unavail‐
able See Owner's Manual message
appears in the multifunction display.
Active Lane Keeping Assist
Important safety notes
Active Lane Keeping Assist monitors the area
in front of your vehicle by means of a camera
at the top of the windscreen. Active Lane
Keeping Assist detects lane markings on the
road and warns you before you leave your
lane unintentionally. If you do not react to the
warning, a lane-correcting application of the
brakes can bring the vehicle back into the
original lane.
:
Active Lane Keeping Assist camera
If you have selected the Display unit
Speed-/odometer (
Y
page 246) function in
the on-board computer and select km as the
unit of measurement, Active Lane Keeping
Assist is active from speeds of 60 km/h. If
the miles display unit is selected, the assis-
tance range begins at 40 mph.
G
WARNING
Active Lane Keeping Assist does not keep
your vehicle in its lane. It is only an aid and
may detect the lane markings on the road
incorrectly or not at all.
The system may be impaired or may not func-
tion if:
R
several or no lane markings for a single lane
are present.
R
there is poor visibility, e.g. due to insuffi-
cient illumination of the road, or due to
snow, rain, fog or spray.
R
there is glare, e.g. from oncoming traffic,
the sun, or reflection from other vehicles.
R
the windscreen is dirty, misted up or cov-
ered, for instance by a sticker, in the vicinity
of the camera.
R
the lane markings are worn away, dark or
covered up, e.g. by dirt or snow.
R
the distance to the vehicle in front is too
small and the lane markings thus cannot be
detected.
R
the lane markings on the road are unclear,
e.g. near roadworks.
Driving systems
215
Driv
in
ga
nd
pa
rk
ing
Z