Mercedes-Benz 2010 GL 350 BlueTEC, Руководство оператора

Страница: 346 / 380

Do not tighten the wheel bolts when the
vehicle is raised. Otherwise the vehicle could
fall off the jack.
Wheel bolt
:
must be used for 19", 20", and
21" light alloy wheels. Wheel bolt
;
must be
used for the Minispare wheel. The wheel bolts
for the Minispare wheel are located in vehicle
tool kit.
!
Wheel bolts
;
must be used when
mounting the Minispare wheel. The use of
any wheel bolts other than wheel bolts
;
for the Minispare wheel will damage the
vehicle’s brakes.
G
Warning!
Make sure to use the original length wheel
bolts when remounting the original wheel
after it has been repaired.
X
Clean contact surfaces of wheel and wheel
hub.
! To avoid paint damage, place wheel flat
against hub and hold it there while
installing first wheel bolt.
X
Guide the spare wheel onto the alignment
bolt and push it on.
X
Insert the wheel bolts and tighten them
slightly.
X
Unscrew the alignment bolt.
X
Install the last wheel bolt and tighten it
slightly.
Lowering the vehicle
X
Attach ratchet to vehicle jack so that the
word
DOWN can be seen.
Lower the vehicle until the vehicle is resting
fully on its own weight:
X
Turn ratchet in direction DOWN.
X
Remove the jack.
X
Tighten the five wheel bolts evenly,
following the diagonal sequence illustrated
(
:
to
A
), until all bolts are tight. Observe
a tightening torque of 110 lb-ft (150 Nm).
344
Flat tire
Practical hints
X164_AKB; 5; 31, en-US
d2ureepe,
Version: 2.11.8.1
2009-09-11T12:30:16+02:00 - Seite 344