Mercedes-Benz 2008 CL-Class, Руководство оператора

Страница: 429 / 769

428
Controls in detail
Automatic transmission
왘
Press the program mode selector
switch repeatedly until the letter of the
desired program mode appears in the
multifunction display.
Select C for comfort driving
(CL 63 AMG and CL 65 AMG: standard
driving):
앫
The vehicle starts out in second
gear (both forward and reverse) for
gentler starts. This does not apply if
full throttle is applied or gear
range
1 is selected.
앫
Traction and driving stability are
improved on icy roads.
앫
Upshifts occur earlier even when
you give more gas. The engine then
operates at lower rpms and the
wheels are less likely to spin.
Select S for standard driving
(CL 63 AMG and CL 65 AMG: sporty
driving):
앫
The vehicle starts out in first gear.
앫
Upshifts occur later.
Steering wheel gearshift control
With drive position D selected and driving
in program mode C or S , you can limit or
extend the gear range.
If your vehicle is equipped with manual
shift program
M , you can use the steering
wheel gearshift control to manually shift
the gears.
i
CL 63 AMG and CL 65 AMG only:
For information on using the steering wheel gear-
shift control in program mode
M , see “Manual
shift program (CL 63 AMG and CL 65 AMG
only)” (
컄
page 430).
!
Allow engine to warm up under low load use.
Do not place full load on the engine until the op-
erating temperature has been reached.
Shift into reverse gear R or park position P only
when the vehicle is stopped.
Avoid spinning of a drive wheel for an extended
period when driving off on slippery road
surfaces. This may cause serious damage to the
drivetrain which is not covered by the
Mercedes-Benz Limited Warranty.