Mercedes-Benz 2002 ML 500, Руководство оператора

Страница: 459 / 539

458
Practical hints
Flat tire
왘
On wheel to be changed, loosen but do
not yet remove the wheel bolts
(approximately one full turn with
wrench).
The jack take-up brackets are located di-
rectly behind the front wheel housings and
in front of the rear wheel housings.
1
Take-up bracket
2
Jack
왘
Place jack
2
on firm ground.
왘
Position jack
2
under the take-up
bracket
1
so that it is always vertical
(plumb-line) as seen from the side,
even if the vehicle is parked on an in-
cline.
왘
Jack up the vehicle until the wheel is a
maximum of 1.2 in (3 cm) from the
ground. Never start engine while vehi-
cle is raised.
!
Do not position the jack on the body of
the vehicle, as this may cause damage
to the vehicle.
!
Vehicles with factory-mounted
running-boards*:
Your vehicle is equipped with a scis-
sors-type jack (located under the cargo
compartment floor) designed for use
with factory-mounted running boards.
Only use this jack when jacking up ve-
hicles with factory-mounted running
boards as otherwise the vehicle’s
underbody can be damaged. See sepa-
rate instructions for scissors-type jack.