T-SI-86.70/131
n
May 2000
11
I.
Version coding and diagnostic testing
1. Connect StarDiagnosis (SDS) to the vehicle and perform the version coding outlined below:
•
Using
path:
Control units/Information and communication/D2B/Control module
adaptations/D2B nominal configuration
,
set the D2B ring configuration per the following table:
Telephone only
D2B Master
Radio (MCS)
D2B Component 1
CTEL 1
2. Return to the D2B functions menu. Using path:
Actual values/D2B Actual configuration
, verify that the
above version coding input (specified value) matches the actual configuration performed during
installation (actual values). If a difference exists, the ring has been improperly configured and MUST be
disassembled, diagnosed, and the error corrected.
=
=
=
=
NOTICE!
DO NOT alter the configuration in step I2 to match the vehicle configuration. Failure to have the
configuration set as indicated in the above table will result in erroneous system operation and/or
intermittent functioning of some or all components.
3. Check the DTC memory of all installed components and the head unit. The source of any present DTC(s)
should be investigated, identified, corrected, and the DTC memory cleared.
Note:
Powering up the newly installed system prior to the above described version coding will set D2B
ring configuration errors. These errors may be ignored during the initial DTC check. If, after clearing the
DTC(s), they return in the next step, a configuration error that must be located and corrected is present.
4. Perform a D2B system group test to confirm that no new DTC(s) have been set.
