FAN INSTALLATION INSTRUCTIONS
5
Rev 2.0
•
Make sure electricity is turned off at the main power box before commencing work. Turn off
the power by removing fuse or turning off circuit breaker before installing the fan and
replacing the lamps.
•
The lowest point on the fan blade must be at least 2.1 metres (7 feet) from the floor.
•
Make sure that ceiling joists are strong enough and of adequate size to support the weight of
about 35 kg.
1.
Fan and light must be earthed during installation.
Secure the mounting bracket to the ceiling joist or
suitable piece of timber inserted between the ceiling
joists. The bracket should be attached with two
timber screws supplied.
2.
Remove the two screws from the covering plate of
the blade-fixing hole. Insert blades one at a time
through four slots around the fan housing and
secure with three screws for each blade through the
top opening. Repeat this procedure for all blades. All
blades are weighted and grouped accordingly,
therefore care should be taken when installing more
than one fan not to mix blade sets.
Fix the covering plate with two screws after
installing blades.
3.
Carefully lift motor body onto hanger bracket. Install
the ball joint into the hanger bracket opening.
Rotate fan until notch on downrod ball engages the
ridge on the hanger bracket. This will allow hands
free wiring.
4.
After connecting wires in accordance to the wiring
diagram provided, align the key holes on the canopy
with the protruding screw heads from the hanger
bracket. Lift the canopy up and rotate until screw
heads engage the key slots fully and tighten. Be
careful not to damage wiring.
