Meranus emily, Инструкция по установке и эксплуатации

Страница: 5 / 52

Final Assembly - Figure 3.
a) • Place the assembled top part on the bottom part of the trolley (10).
b) • Place the cable hook (5) and its cover (6) on the assembly
• Insert the bolt (7) under the cable hook and tighten it with
the spanner.
• Insert 2 long bolts (8) into the hook cover, holding the nuts (9)
in the cable hook , and tighten them.
ELECTRICAL CONNECTION
For optimum performance, we recommend you place the trolley
with the control unit midway along the length of the pool.
Figure 4a.
For your safety, and to obtain the best possible performance from
your robot, proceed as follows:
• Position the control unit at least 3.5 metres from the edge
of the pool, avoiding direct exposure of the unit to the sun.
It can be either placed on the ground or hooked onto the trolley
as illustrated in Figure 6.
• Connect the robot’s cable to the control unit and lock the
connector. Figure 4b.
• You should only connect the control unit to a plug protected
by a safety system with a residual current of 30 mA maximum
(if in doubt, contact an electrician installer).
VERY IMPORTANT!
If you use an extension lead to connect your cleaner
to the mains, make sure that the control unit cannot
be placed within 3.5 m of the edge of the pool.
IMMERSION OF THE ROBOT
IMPORTANT: Do not allow anyone to use the pool when
the robot is in it.
Put the robot into the water and expel the air from it.
Turn it upside down if necessary. Figure 5.
It is essential for the robot goes down into the water by itself
and places itself on the bottom of the pool.
Roll out the cable over the whole length of the swimming pool to
reduce hindrance to the robot movements.
ASSEMBLY AND INITIAL USAGE ASSEMBLY AND INITIAL USAGE
Fig
ure
5
F
igu
re 3
b a
Fig
ure
4
5 4
b
a
trolley
3,5 m