Mendip Stoves ASHCOTT Wood, Руководство по эксплуатации и установке

Страница: 8 / 32

8
Note: If the chimney is externally fitted or the stove has been installed
on a larger diameter clay chimney liner then on cold days it maybe
necessary to warm the flue using firelighters prior to lighting with wood.
1
. Place a few smaller pieces of dry wood (kindling) in the stove on top of
the non toxic firelighters, place one small dry split logs (¼ split) on top.
Kindling stacked as in diagram allows combustion air flow freely and will
aid ignition (fig 1) .
2.
Fully slide open (fully to left) the air control air slider below the stove
door. The stove now has full secondary air for start up.
3. Place door spacer tool on magnet latch on the door (fig 2), light the
firelighters and push door to closed position, with the door space tool the
door is open approximately 2 mm. (fig2) This provides additional
combustion air for start up and reduces condensation on the door glass.
4. Once the flames from the logs are fully established , this can take up to
10 min's . The door can now be closed, remove door spacer tool and push
door closed until magnetic closure has located. Leave the air control in
the far left position . If the stove flames begin to falter and generate smoke
in chamber unlatch the door again and place door space tool on again
until the fire is established.
5. Once the fire bed is established slide air control to the middle position
position, for the stove to burn cleanly plenty of secondary air is needed,
do not be tempted to shut the fire down too early as this may cause smoke.
At nominal heat output, expect to refuel your stove approximately once
an hour. Check load weights for your model on the table on page 4.
Use the glove when operating air controls and door.
MENDIP STOVES RECOMMEND THE USE OF A FLUE THERMOSTAT TO CHECK
YOUR STOVE IS NOT OVERHEATING. PLACE FLUE THERMOSTAT DIRECTLY
ABOVE COLLAR OF STOVE AND REFER TO TEMPERATURE GAUGE ON PAGE
4.
HOW TO LIGHT YOUR WOODBURNING STOVE
The stove will get very hot during use and due care must therefore be exercised.
Please use the glove when operating air controls , door and ashpan.
(fig 2)
RE-FUELLING WHEN BURNING WOOD
To re-fuel your stove in the cleanest way only refuel your stove when flames have died down and you have glowing embers.
Before refuelling, open air control fully (slide to the left). Unlatch door to equalise pressure with the room. Open door
gently, add one piece of wood (4.7 kW model) (please check weight table page 4) and close the door. Once the flames
from the logs are fully established slide air control to central position.
The stove is only suitable for intermittent use only: do not run overnight or for long periods unattended.
USE OF HOUSE COAL AND PETROLEUM COKE ARE NOT SUITABLE FOR
THIS STOVE; ITS USE WILL INVALIDATE THE GUARANTEE.
(fig 1)