Menards MASTERFORCE 260-9519, Руководство оператора

Страница: 9 / 16

Page 9
5. CONNECTING CONVERTER CABLES
The converter and power source must be in the OFF mode.
IMPORTANT: Make sure you connect your converter to a 12-volt power
supply only.
CONVERTER CONNECTION
1.
Locate the positive and negative plastic terminals located on the right
side of the converter and remove the terminal caps completely.
2. Install the positive (red) cable ring lug onto the positive (red) termi-
nal screw. Install the negative (black) cable ring lug onto the negative
(black) terminal screw. Tighten each terminal so that the cable cannot
come loose.
CONNECTING CONVERTER CABLE TO A VEHICLE
(100 WATTS MAXIMUM):
1. Remove the cigarette lighter from its outlet.
2.
Push the 12-volt power plug firmly into the outlet.
CONNECTING CONVERTER CABLES TO 12V BATTERY
OR 12V POWER SOURCE:
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and clothing protection.
3. Connect the positive (red) converter terminal cable to the power source
positive (+) or battery terminal. Make sure the connection is secure.
4.
Connect the negative (black) converter terminal cable to the power
source negative (-) or battery terminal. Make sure the connection is
secure.
5. To disconnect the converter, reverse the above steps.
NOTE: The internal speaker may make a brief “beep” when the converter
is being connected to or disconnected from the 12-volt power source.
IMPORTANT: Failure to make the correct connections will result in blown
fuses and permanent damage to the converter.