Getting Started
MEN Mikro Elektronik GmbH
11
1
Getting Started
This chapter gives an overview of the board and some hints for first installation in a
system.
1.1
Map of the Board
Figure 1.
Map of the board – top view
1.2
Integrating the Board into a System
You can use the following check list when installing the board in a system for the
first time and with minimum configuration.
Power-down the system and remove the CPU board.
Install the GM3 in the corresponding slot on the CPU board as described in the
CPU board’s user manual.
Insert the CPU board into the system again.
Power-up the system.
If there is a system crash or other abnormal behavior at start-up, check if the
GM3 is plugged in properly.
Board
to
Board
Connector
Quad
Gigabit
Ethernet
controller
mSATA
SSD
slot
CompactPCI
Serial
Connector P6