Fig. 5
Fig. 1
Fig. 4
Fig. 2
Adjust Fork Clamp Bushings as
needed and check for clearance.
(See above "Read and Follow
Directions Warning.")
Bushing Assembly
1. Place lower slot into lower bushing.
2. Rotate top slot into place.
3. Secure locking Mechanism.
4. Loosen Allen Bolt to adjust angle,
then re-tighten Allen Bolt.
1
2
3
4
CORRECT
Fully engaged
Locking mechanism
NOT CORRECT
Latch assembly
Fig. 6
5. Loosely install the four Fork Clamps on the forks,
approximately 2" apart. (Fig. 3)
6. Adjust Fork Clamp Bushings as needed and check for
clearance. (Fig. 4) (See warning above.)
7. Slip the mounting plates and fairing onto the fork
clamps, (Fig. 5) while guiding the bezel over the headlight
(Fig. 2) and secure the left and right side locking mecha-
nism
8. Adjust the height, angle and alignment of the fairing and
tighten
ALL
bolts.
Note: This is a detachable fairing, ALWAYS make sure
the Locking Mechanism is Fully Engaged after install-
ing the fairing! (Fig. 6)
2. Mounting Instructions, continued
Install top mount
headlight spacer
Headlight housing
Headlight bracket
Space Approx.
2" apart.
WARNING:
Mounting clamps
backwards will cause
damage to your tank.
Throttle side,
front of bike
INCORRECT
CORRECT
Fig. 3
Headlight Bezel
