page 9
4.2 Switching on
The bath is switched on by pressing the push/turn control.
Bath switched off. The push/turn control is
pushed in and protected against damage.
Bath switched on and can be operated using
the push/turn control and the SET key.
4.3 Setting the parameters
A parameter can be selected by rotating the push/turn control; all other parameters are then dimmed.
The selected parameter flashes brightly and can now be altered with the push/turn control while holding
down the SET key (protection against unintentional alteration).
If the push/turn control is rotated quickly the setpoint is altered in large steps; with slow operation it is
altered in single steps.
After the SET key has been released the newly set value is stored.
Further rotation of the push/turn control selects the next parameter.
Rotation of the push/turn control selects the following parameters (in the order indicated), to be altered
as described above:
Temperature setpoint
Delayed switch-on
Hold time of the setpoint temperature
1.
2.
3.
BASIC
