Member's Mark TF2038101-MM-01, Руководство по сборке, использованию и уходу, Страница: 10 / 19

TF2038101-MM-01 English
P. 10
20190508 Ver1
Burner Flame Check

Light burner, rotate valve knob from
HIGH to LOW. You should see a
smaller flame in LOW position than
seen on HIGH. Always check flame
prior to each use. The air damper
(D) mounted on the back of your
burner helps to control the amount
of primary air that mixes with the
LP gas. A blue flame with little or no yellow flame provides the best heat. Adjust the air damper by
turning it clockwise or counterclockwise until the desired flame is achieved.
Turning LP Cooker Off

Turn all knobs to OFF position, Turn LP tank OFF by OPD turning hand wheel clockwise to a full
stop.
Regulator and Hose Assembly Check

Before each use, check to see if there is evidence of abrasion, wear, cuts or leaks , the hose must
be replaced prior to the appliance being put into operation. The replacement hose assembly shall
be that specified by the manufacturer.

Cleaning and inspection of pressure regulator and hose assembly prior to use.
Cleaning the Burner
CAUTION
Checking and cleaning burner / venture tubes for insect nests. A clogged tube can lead to fire
beneath the appliances.
Spiders
’ nests or wasps’ mud inside the burner may cause fire at the air damper. If a fire occurs,
immediately turn off gas supply at LP tank valve using OPD Hand Wheel.
Note:
Spiders and small insects can spin webs and build nests inside the burner. This especially occurs in
late summer and fall before frost when spiders are most active. These nests can obstruct gas flow and
cause a fire in and around the burner and orifice. Such a fire can cause operator injury and serious
damage to the appliance.
To help prevent a blockage and ensure full heat output, clean and inspect burner tube often (once or
twice a month). NOTE: Water or air pressure will not normally clear a spider web.
Steps for Cleaning the Burner:
1. Remove orifice / hose from the burner.
2. Look inside the burner tube for nests, webs, or mud.
3. To remove the above obstructions, use an accessory flexible venture
brush or bend a small hook on one end of a long flexible wire such as the
one in small picture.
4. Inspect and clean the burner if needed.
5. Reattach orifice / hose to burner.
Cleaning and Maintenance

Keep appliance area clear and free from combustible materials, gasoline and other flammable
vapors and liquids.

Do not block holes in bottom or sides of appliance.

Check burner flames regularly.

Use appliance only in well-ventilated space. NEVER use in enclosed space such as carport,
garage, porch, covered patio, or under ANY overhead construction.