Member's Mark GAS9670AS, Руководство пользователя

Страница: 11 / 33

MATCH LIGHTING THE MAIN BURNER:
1. Open lid before lighting burner.
2. Make sure all control knobs are “OFF”.
3. Place a paper match in the end of the matchlighter. Strike match and
place through the cooking grate approximately 1/2” (1 to 2 cm) from
the burner to be lit.
4. Turn burner control knob to “HIGH” position. The burner should light
within 5 seconds.
5. If burner does not light, turn control knob to “OFF” and wait 5 minutes for gas to dissipate and repeat
lighting procedure.
6. Once lit, light adjacent burners by following steps 3-6.
7. If burner does not light within fi rst few attempts of match lighting, there is a problem with the gas supply.
Turn off gas at burner and cylinder. DO NOT attempt to operate grill until the problem is found and
corrected.
Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
LIGHTING THE SIDE BURNER:
1. Open lid before lighting side burner.
2. Make sure control knob is “OFF”.
3. Push and hold down side burner control knob and SLOWLY
(2 to 3 seconds) turn to “HIGH”. You should hear the igniter click.
Note: Step 3 may need to be repeated 2-3 times to light side burner.
4. If ignition does NOT occur in 5 seconds, turn control knob to “OFF”, wait
5 minutes to allow gas to dissipate and repeat lighting procedure.
5. If burner does not ignite using the igniter, see “Match Lighting the Side
Burner” section.
6. To turn off, turn control knob clockwise until it locks in “OFF” position.
Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
MATCH LIGHTING THE SIDE BURNER:
1. Open lid to the side burner before lighting.
2. Make sure control knob is “OFF”.
3. Place a paper match in end of the matchlighter..
4. Strike match and hold it approximately 1/2” (1 to 2 cm) from burner.
5. Turn side burner control knob to “HIGH” position. The burner should light within 5
seconds.
6. If burner does not light, turn control knob to “OFF” and wait 5 minutes for gas to dissipate
and repeat lighting procedure.
7. If burner does not light within fi rst few attempts of match lighting, there is a problem with the gas supply. Turn off
gas at burner and cylinder. DO NOT attempt to operate grill until the problem is found and corrected.
Note: If burner does not light or fl ame is too low, See “Trouble Shooting” section of the owners manual.
Note: Observe fl ame height when lit: Flame should be a Blue/Yellow color between 1”–2” when burner is on
“HIGH”.
10
MATCHLIGHTER
LIGHTING THE SEAR BURNER:
1. Open lid before lighting sear burner.
2. Make sure control knob is in the “OFF” position.
3.
Push and turn burner control knob to “HIGH” position.
4. Press igniter for 3–5 seconds to light burner.