16
TRANSPORTATION AND STORAGE
1.
Place dust cap on cylinder valve outlet whenever the cylinder is not in use.
Only install the type of dust cap on the cylinder valve outlet that
is provided with the cylinder valve. Other types of caps or plugs
may result in leakage.
2.
Always transport in an upright position.
3.
Do not smoke when transporting your cylinder.
4.
Keep cylinders out of direct sunlight and away from sources of heat.
Your regulator is equipped with a Q.C.C. Type 1 quick connect system. It will not allow gas to flow until a
positive seal has been made. It has a flow-limiting device that will restrict the flow of gas to 10 cubic feet per
hour (0.28 cubic meters per hour).
TO PLACE THE CYLINDER INTO THE GRILL CABINET
1.
Place the tank onto the sliding LP cylinder tray.
2.
The front of the tank valve should face to the front of the cabinet.
3.
Unhook the LP cylinder support ring and lower it down over the
neck of the LP cylinder. Reattach the hook to secure.
4.
Lock the LP cylinder tray in place by turning the LP cylinder
tray stopper to a right angle.
TO CONNECT THE CYLINDER TO THE REGULATOR AND HOSE
1.
Be sure the LP cylinder is “OFF” by turning the hand wheel clockwise
until it stops.
2.
Place the cylinder into the base cabinet shelf of the grill with the valve
facing outward and secure with the cylinder retaining bolt.
3.
Be sure all burner controls are turned to the “Off” position.
4.
Remove the safety cap from the cylinder valve.
5.
Center the nipple of the regulator into the cylinder
6.
Turn the black nut clockwise until it stops.
Hand Tighten Only.
Do Not Use A Wrench.
Dust Cap
CAUTION
The pressure regulator and hose assembly provided with this gas grill must be used. This regulator is set for an
outlet pressure of 11 inches water column. Replacement pressure regulators and hose assemblies must be those
specified in the parts list.
!
Regulator and LP Cylinder Connections
