Mellanox Technologies SX1012, Руководство пользователя

Страница: 39 / 107

Rev 1.4 42 Mellanox Technologies
Step 2.
Configure a serial terminal program (for example, HyperTerminal, minicom, or Tera Term)
on your host PC with the settings described in
Table 9 . Once you perform that, you should
get the CLI prompt of the system.
Table 9 - Serial Terminal Program Configuration
Parameter
Setting
Baud Rate 9600 or 115200 (see below)
Data bits 8
Stop bits 1
Parity None
Flow Control None
Step 3.
Login as admin and use admin as password. On the first login, the MLNX-OS configuration
wizard will start.
Step 4.
To configure network attributes and other initial parameters to the system, follow the con-
figuration wizard as shown in
Table 10 .
The baud rate is different per CPU type of the system.
The systems based on x86 CPU (SX1400) should be configured with baud rate =
115200, while the rest of the systems (based on PPC460),should be configured with
9600.
Table 10 - Configuration Wizard Session - DHCP
Wizard Session Display Comments
Mellanox configuration wizard
Do you want to use the wizard
for initial configuration? yes You must perform this configuration the first time you operate
the system or after resetting the system. Type ‘y’ and then press
<Enter>.
Step 1: Hostname? [switch ] If you wish to accept the default hostname, press <Enter>. Other-
wise, type a different hostname and press <Enter>.
Step 2: Use DHCP on mgmt0
interface? [no] yes Perform this step to obtain an IP address for the system. (mgmt0
is the management port of the system).
If you wish the DHCP server to assign the IP address, type ‘yes’
and press <Enter>.
If you type ‘no’ (no DHCP), then you will be asked whether you
wish to use the ‘zeroconf’ configuration or not.
If you enter ‘no’ (no Zeroconf), you must enter a
static IP, and the
session will continue.
Step 3: Enable IPv6? [yes] The management interface will be able to use IPv6 addresses.
Step 4: Enable IPv6 auto-con-
fig (SLAAC) on mgmt0 inter-
face? [no] This turns on auto-configuration of the IPv6 addresses. This is
unsuitable for DHCPv6.
If you enter "no" (no IPv6), you will automatically be referred to
Step 6.